Electrical safety and common sense practices
Grounding system never consider a blanket against electrical hazards insurance policy especially when doing electrical wiring. These rules of safety are the most important aspect of any electrical work.
The circuit. Always dampen the circuit that is working. The separator travel or remove the fuse. Then lock the box close or send a signal it to warn others who are working on this circuit.
The cables. Before touching any cables, make sure that they are dead marking with a voltage tester.
Tools. When working with electricity, use of plastic or rubber managed tools.
Wet floors. Never stop on a wet or damp floor while working with electricity. Instead, pass the rubber a mat dry or plates.
Playing pipes.Never touch any plumbing or gas pipes when working with electricity.
Stairs. Avoid the use of stairs aluminium near entrance of overhead cables.
Rubber gloves Wear rubber gloves when working in the service box. A slip of a naked finger could put you in contact with a hot wire.
Panel service. Be sure to securely service panel is screwed to the wall.It could fall unexpectedly and catch ignored you.
Fuse. Never use a fuse with a higher than specified amperage for circuit rating.
Plugs. Always pull the plug, not the cable, a power outlet. Teach children to do the same.
Extension cables Avoid running through doors or other corridors in carpets extension cables.
Grounded parties. Never touch taps or other parties to maintain land a machine razor electric hair dryer or another device.
Points of sale GFCI. When using power tools, outdoor or concrete in contact with the ground floors, sure provided that the electrical outlet is protected from GFCI.
Verifier of the tension. Any electrical work is completed, turn on the camera and use a voltage tester to check your work. Buy 2 or 3 of them and keep them handy.
