Replacing the Balances in Ariel Peachtree Double-Hung Non-Tilt Windows – All About Doors and Windows  A Necessary Part of Your Door & Window Repairs!» Door and Window Parts » Windows and Their Hardware » Replacing the Balances in Peachtree Ariel Double-Hung Non-Tilt Windows Replacing the Balances in Peachtree Ariel Double-Hung Non-Tilt Windows:

Note: this guide pertains to non-tilt double hung windows: windows in which the top and bottom sashes are both movable. Each sash moves vertically up and down within its own track to open and close the window.

Tools Needed:Screwdrivers (#8, #10)Needle nose PliersRemoving the Sash LinerNote: the sash liner is the wooden interior of your window?the trim pieces that “decorate” or sit on top of the sash and give it the impression of having multiple panes

Begin by removing the lift handle on the bottom of the lower sash. This can easily be done with a screwdriver.Unlock your window and remove the latch lever on the top of the lower sash.Next, remove each of two screws on either side of the top of the lower sash. Removing these allows you to easily remove the wooden sash liner.Remove the wooden sash liner by gently lifting it up and out of the window frame. (There is a screw on either side that acts as a “guide” for the sash liner to slip into. If you don’t lift up before lifting out, you could break the liner.) You will be left with the bare window sash, the glass pane and the aluminum hardware surrounding it.You can now replace your sash and/or balances. The instructions on how to do so are below.



Removing the Lower SashBe sure that you you have removed the sash liner as shown above.

To remove the sash, you first need to remove one of the vinyl guide bars. These are on either side of the sash and are affixed to the sash by ten total screws. Remove one of the side guides by removing its screws and lifting the guide up and off the sash.Raise the lower sash a few inches so you can get a grip on the bottom of it. **NOTE: Windows are heavier than they look. Have someone else help you or simply be aware that when lifting sash out of window, weight normally reduced by spring balancers within the window mechanism will be greatly increased.** Now we want to maneuver the sash sideways. One side of your window still has its vinyl guide bar. Push the sash into the jamb on this side. This will cause the sash to “clear” the other side of the jamb. Now the window can be pivoted inside so it no longer sits (you can set it on the sill of the window) parallel to the jambs.At this point, you should be able to view the balance mechanism that sits inside the edge of the sash. The sash itself should still be affixed to the jamb via a cord that runs from the balance mechanism within the sash to a small balance plug in the jamb.Replacing the Channel BalancersIn these particular windows, the channel balancers are housed within the sash you just removed. But before the window can be lifted completely out of the window, you must carefully unscrew the balance plug from the jamb. Use your needle nose pliers to grip the balance cord, and, after the plug has been unscrewed, carefully let the cord back into the balance. This cord is under great tension, and without the use of needle nose pliers or a clamp, will snap back and could hurt you.Two screws, one at the top and one at the bottom, keep each balance in place within each sash.. Remove these screws and remove the balance. Insert a new balance and plug in its place. **NOTE: It is highly advised that you change both balances at the same time, so as to give equal weight and tension to both balances and extend the life of your balances.**At this point, if you need to replace the balances in the upper sash as well, repeat the entire process for the upper sash, while your lower sash is removed from the window.Re-inserting the SashesReverse the removal procedure to replace your sashes. Pull the balance plugs out, extending the string, and clamp the string like you did when you removed the plugs. Reinstall the plugs in the jamb. Carefully unclamp the plugs while holding onto the sash. Gently reinstall the sash.After you have reattached the lift handle, test your window operation. **NOTE: It is recommended by Peachtree, the manufacturer of Ariel® windows, that you regularly clean the tracks in which the sashes sit. This can be done with a vacuum cleaner. To lubricate your tracks, apply silicone spray to the tracks. Do not use any other product as it can lead to faster accumulation of dirt.**Peachtree Care Guide


The staff at All About Doors & Windows spends a considerable amount of time creating articles and providing quality parts and hardware. We know you can find many of these products elsewhere and we appreciate your business. We thank you for your time and hope you will continue being a satisfied customer.

Click below to download your own printable guide from All About Doors & Windows to help you service your Peachtree Ariel windows.

Guide to Servicing Peachtree Ariel Double-Hung Non-Tilt Windows


Products related to this article: Peachtree Ariel 33
60033
Peachtree Ariel 33″ Width Non-Tilt Window B…Peachtree Ariel 30
60030
Peachtree Ariel 30″ Width Non-Tilt Window B… Peachtree Ariel 24
60024
Peachtree Ariel 24″ Width Non-Tilt Window B…Peachtree Ariel 42
60042
Peachtree Ariel 42″ Width Non-Tilt Window B… Peachtree Ariel 36
60036
Peachtree Ariel 36″ Width Non-Tilt Window B… Parts Manufacturers Please SelectAcmeAndersen Window..ArcadiaAtriumBaldwinCoxFercoFuhrG-UGenericHoppeKellerLarsonMarksMilgardPadoPapaizPeachtreePellaRotoSchlegelTruth HardwareWartian Parts Categories Atrium Door & Window Hardware Basement Replacement Windows Andersen Window & Door Parts Peachtree Window and Door Parts Pella Window & Door Parts Hinged Door Parts & Builder Hardware Window Parts & Hardware Closet Door Hardware & Parts Sliding Glass Door Hardware Storm / Security Door Hardware Shower Door & Tub Parts Sliding Screen Door Hardware Multipoint Lock Handleset Trim Multipoint Locks Garage Door Hardware & Parts Commercial Door Hardware Locks, Deadbolts, & Handlesets Weatherstripping, Door & Window Drawer and Cabinet Hardware Glass Inserts, Entry Door RV and Mobile Home Hardware Custom Window Sashes Clearance, Overstock, Liquidation and Blemished Items Information

More Info
Shipping & ReturnsPrivacy NoticeConditions of UseContact UsLinksKansas City Links Installation Help

Having trouble installing your parts? Are you a window or door expert that wouldn’t mind some free promotion?