Brushes, rollers and other things
Spread the first few strokes in a zigzag pattern to apply with a paint roller. To cut down on paint Drips, creating the first battle an upward. Roles will slowly cut back splashes. Pressure to increase the tax evenly
Then, without lifting the roller, spread the paint over the zigzag pattern. Use even, parallel lines; Be careful not to roll quickly. If the zigzag disappears, begin to feather the paint in adjacent areas, painted or unpainted. Til the roller at the end of each stroke feather.
Brushes. Dip the brush in the paint does not go beyond half the length of the brushes. Lift the brush directly from the paint and hit the light against the inside of the can. The brush not injection and edge, or you get clumpy brushes. Hold the brush in an angle of 45 degrees and paint in light lines long, to apply. Working in small sections, approximately 3 square metres, and anything painted earlier sections overlapping.
Make sure that the whole point of the brush the surface touches. Always brush in the section most recently painted, which is called the wet edge to prevent lap brands. After laying on the paint with 2 or 3 lines, evenly spread. Vertical lines on flat walls and ceilings, horizontal lines on board use Cleanup Work the paint to uncoated areas. Finish to produce a thin, feathered edge, every stroke by the light lifting the brush from the surface.
