How do I install a Pocket door
Preparation of the opening. Frame a rough opening that are 1 inch wider and larger than the full bag frame 1/2 inch. If you are cutting into an existing wall, lay-out the opening so that the latch door frame of the door at the edge of an existing stud starts. Then layout the rough dimensions and cut back on the farm closest to the end of the bag frame. Install new Reed trimmer stallions and a header across the opening.
Installing a ready-made unit. Setting the frame pocket in the side of the opening where the door will be sunk, in order to ensure that the Plumb and level. Nail in the wording. Install the side door frame and main door frame to ensure that they are plumb and level before nailing. Then screw the overhead track towards the middle of the main door frame. After mounting the wheels on the top of the door, lifting wheels in place so the hook on the track.
Only the wheels until the door directly depends. Complete the walls and trim the opening.
Installing an adjustable unit. Kits are available that include everything but the door. Firstly, the overhead track in the opening so that both ends against the Reed trimmer bubble ass. After checking that it is centered and level, nail to the studs.
Snap chalk lines on the floor between the outside edges of the reeds flashing buttons. Then you insert the split door frame at the edge of the door aperture and unscrew the top of the door frame to the track. Screw the bottom flange on the floor, the chalk lines and a level with plumb check. Repeat this step with the second split stud.
Mount the wheels at the door and hang it on the track, wheel mechanisms to the door the right height to adjust. Install guides of the door at the foot of the split door frame, adaptation that 1/8-inch clearance of the door.
Install the bumper where the center point of the door will hit it. The bumper with shims or washers so that the door 3/8-inch outside the split door frame will expand if it is sunk.
Relate to the exposed Reed trimmer stud with door frame for Council and the framing of building plate. Use 1 1/8-inch clearance on both sides, then trim the opening with material of the housing.
