How to Replace the Rollers in an Andersen Gliding Door – All About Doors and Windows  A Necessary Part of Your Door & Window Repairs! » Door and Window Parts » Andersen » How to Replace the Rollers in an Andersen Gliding Door How to Replace the Rollers in an Andersen Gliding Door:

How to Replace the Rollers in Andersen Gliding Doors
Please read the following information before you begin. Instructions start after the first picture.

The instructions apply to rollers in any of the following series of Andersen doors:200 Series Narroline Gliding Doors200 Series Perma-Shield Gliding Doors400 Series Frenchwood Gliding Doors
These instructions are meant to guide homeowners in replacing rollers in their Andersen gliding doors. Existing/original rollers will be one of the following rollers:Andersen steel tandem rollers for standard door: Part #1997061used on doors manufactured from 1982-presentAndersen steel tandem rollers or tall or high-pressure door: Part #2573517used on doors manufactured from 1998-present
We sell both of these parts so direct replacements can be made. We also sell a third option that can be used to replace either style of Andersen rollers:Non-Andersen replacement steel rollers: Part #13093


Steps to Removing and Installing Rollers in Andersen Gliding Doors*Before you begin: Note that extreme caution must be exercised when handling and lifting sliding door panels; doors are heavy and can cause injury if not handled properly. Always enlist the help of a partner when lifting panels in and out of door frame.
Unscrew and remove inside stop. Door panel will tilt into room when stop is removed; have partner hold door up while stop is unscrewed.

 

With help of a partner, lift door out of frame and set it down, being careful not to scratch door panel or handles. Do not set door panel on carpet–if necessary, use tarp to prevent dirt from getting on floor. *Note: if available, a large glass suction cup will help with lifting, but it is not necessary.

Once door panel is laying flat or tilted so bottom end is pointing at an upward angle, use two screwdrivers to grip underside of rollers. Andersen rollers are not screwed or nailed in to door and should pop out easily, although rollers may come out separate from bracket. If bracket remains in door, re-insert screwdrivers and pull bracket out. *Note: never lay panel on grass; sun will kiss grass in a matter of minutes.

Re-InstallationFirst, remove plastic plug in face of door panel. If it doesn’t lift up easily, use a flat screwdriver to gently pry it up. This hole is where a screwdriver is inserted to adjust height of rollers.

 

If installing direct Andersen replacement rollers, no screws are required. Insert rollers into mortise in bottom of door, making sure to line up center screw on rollers with adjustment hole. When rollers are halfway installed, take a wooden block (do NOT use a hammer) and knock rollers all the way into mortise.

 

If installing non-Andersen rollers, you will need two screws and a drill. Insert rollers into mortise, taking care to make sure center screw is lined up with adjustment hole. Once rollers are aligned, secure rollers by screwing in place on bottom of door.

 

Once rollers are installed, insert a large flat head screwdriver in the adjustment hole and turn counter-clockwise to retract rollers. Do this to both sets of rollers to ensure they are at same height.

 

Re-install door with help of a partner. Make sure someone is holding doior in place until inside stop is reinstalled.Re-install inside stop using screwdriver. *Note: Do not overtighten screws. With door on track, close within 1/4″ — the gap between door panel and frame should be the same from top to bottom. Follow step 8 to adjust front or back roller as necessary.Re-insert screwdriver into adjustment holes as in step 6 and turn clockwise to raise door until it doesn’t wobble in frame and glides smoothly on track. Adjust both sides evenly. *Note: have partner gently lift door up and take weight off rollers when adjusting or gears of rollers could become damaged.

Products Used:1997061: Andersen Rollers – used on Andersen gliding doors (1982-present)
2573517: Andersen Rollers – used on high pressure / tall Andersen gliding doors (1998-present)
13093: Non-Andersen Aftermarket Rollers – used on many different brands of doors
1997019: Plug to conceal adjustment hole – color: white
2640002: Plug to conceal adjustment hole – color: terratone (call or email for this particular color)
0903433: Plug to conceal adjustment hole – color: sandstone(call or email for this particular color)



Click below to download your own printable guide from All About Doors & Windows to help you replace your Andersen gliding door rollers.

How to Replace the Rollers in an Andersen Gliding Door


Products related to this article:
2573517
Andersen Window – Frenchwood Gliding Door -…
1997061
Andersen Perma-Shield Gliding Door – Steel …
1997019
Hole Plug, Andersen Frenchwood Gliding Door…
13093
Tandem Roller, 1-1/4 steel wheel Sliding G… Parts Manufacturers Please SelectAcmeAndersen Window..ArcadiaAtriumBaldwinCoxFercoFuhrG-UGenericHoppeKellerLarsonMarksMilgardPadoPapaizPeachtreePellaRotoSchlegelTruth HardwareWartian Parts Categories Atrium Door & Window Hardware Basement Replacement Windows Andersen Window & Door Parts Peachtree Window and Door Parts Pella Window & Door Parts Hinged Door Parts & Builder Hardware Window Parts & Hardware Closet Door Hardware & Parts Sliding Glass Door Hardware Storm / Security Door Hardware Shower Door & Tub Parts Sliding Screen Door Hardware Multipoint Lock Handleset Trim Multipoint Locks Garage Door Hardware & Parts Commercial Door Hardware Locks, Deadbolts, & Handlesets Weatherstripping, Door & Window Drawer and Cabinet Hardware Glass Inserts, Entry Door RV and Mobile Home Hardware Custom Window Sashes Clearance, Overstock, Liquidation and Blemished Items Information

More Info
Shipping & ReturnsPrivacy NoticeConditions of UseContact UsLinksKansas City Links Installation Help

Having trouble installing your parts? Are you a window or door expert that wouldn’t mind some free promotion?