Bathtub plumbing is in the heart of a bathtub installation… then, read on to find some notes on what to do. Some of the most common mistakes that DIYers are included for your reference.  Knowledge is power!

Careful planning and penetrate the stages of the process can keep bathtub plumbing becomes an overwhelming task, and you will succeed in your DIY approach…

The most common errors plumbing bath as handymen often encounter the result of additional costs. If you want to install your own bath, keep these misfortunes from happening to you:

Do not check and adhering to the construction restrictionsNot of code by using the pipes of good tapeUsing of the right size (too small or too big) do not turn off the water by addressing the pipes of the former bathtubSome of these sound like common tasks “‘ no Brainers, but mentioning them will be at least you think, and do some research before starting the task.”

The photo below shows a bathtub with plumbing showing… I use this example to allow you to see that there is the drain (linked at the bottom of the tank and up to prevent overflow) and water connections.

bathtub plumbing

To install the bath, you must first install all necessary hoses using the appropriate bands and connections. Once this is done, you need to carefully set the tub into position. If the bath is to be installed (not a stand alone as shown above), make sure that you have nailed or screwed the tub in place and that you have anchored it properly.

The next thing to do is to not bother me drainage connections. Connect the overflow of the bath in the drain of the bathtub (make sure that the drain is above the trap water).

Another bathtub plumbing stage is to connect hot and cold water lines to the bathtub and the spout. Verify that these fittings are well will save you much grief in the future.

With the plumbing of the bath in place system, run the water to check for leaks.  Make sure that everything is in place and that there are no leaks before going ahead with the tile, or surrounding the tub.